Air King SEV28S Průvodce řešením problémů

Procházejte online nebo si stáhněte Průvodce řešením problémů pro Odsavače par Air King SEV28S. Air King SEV28S Troubleshooting guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
IMPORTANT INSTRUCTIONS -
OPERATING MANUAL
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electric shock and injury to person, including the following:
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer.If you have
questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service panel
and lock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as
a tag, to the service panel.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
INJURY TO PERSON, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
b) Sufficient air is needed for proper combustion and exhausting of gases
through the flue (chimney) of fuel burning equipment to prevent back
drafting. Follow the heating equipment manufacturer’s guideline and
safety standards such as those published by the National Fire Protection
Association (NFPA) and the American Society for Heating, Refrigeration,
and Air Conditioning Engineers (ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
CAUTION: TO REDUCE THE RISK OF FIRE AND TO PROPERLY
EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE - DO NOT VENT
EXHAUST AIR INTO SPACES WITHIN WALLS OR CEILINGS OR INTO
ATTICS, CRAWL SPACES, OR GARAGES.
d) Ducted fans must always be vented to the outdoors.
e) This unit must be grounded.
f) To avoid motor bearing damage and noisy and/or unbalanced impellers,
keep drywall spray, construction dust, etc. off power unit.
g) Read all instructions before installing or using exhaust fan.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, DO NOT
USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE.
WARNING: TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils
slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when
flambéing food (ie. Crepes Suzette, Cherries Jubilee,
Peppercorn Beef Flambé).
c) Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan filter.
d) Use proper pan size. Always use cookware appropriate for the size
of the surface element.
WARNING: TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
a) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal
tray, then turn off burner. BE CAREFUL TO PREVENT BURNS. If the
flames do not go out immediately, EVACUATE AND CALL THE FIRE
DEPARTMENT.
b) NEVER PICK UP A FLAMING PAN - You may be burned.
c) DO NOT USE WATER, including wet dishcloths or towels -
a violent steam explosion will result.
d) Use an extinguisher ONLY if:
I. You know you have a Class ABC extinguisher, and you
already know how to operate it.
II. The fire is small and contained in the area where it started.
III. The fire department is being called.
IV. You can fight the fire with your back to an exit.
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.
www.airkinglimited.com
6728012 Rev. J 11-14 1 of 12
Power Unit
Models: SEV24S, SEV28S, SEV30S,
SEV24AB, SEV28AB, SEV30AB
Zobrazit stránku 0
1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - OPERATING MANUAL

IMPORTANT INSTRUCTIONS -OPERATING MANUALREAD AND SAVE THESE INSTRUCTIONSREAD CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE

Strany 2 - Power Unit

www.airkinglimited.com6728012 Rev. J 11-14 10 of 12Installateur : Date d’installation : Endroit de l’achat : Numéro de modèle : GARANTIE LIMITÉE

Strany 3 - SECTION 7

www.airkinglimited.com6728012 Rev. J 11-14 11 of 12TABLEAU DES PIÈCES DE RECHANGE # de pièce de # Qté. Description remplacement 1

Strany 4 - CUSTOMER SERVICE:

www.airkinglimited.com6728012 Rev. J 11-14 12 of 12REMARQUE

Strany 5 - REPLACEMENT PARTS DIAGRAM

INSTALLATION INSTRUCTIONSCAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION.SECTION 1Preparing the Insert1. Unpac

Strany 6 - 6728012 Rev. J 11-14 6 of 12

2. Attach the wire compartment to the power unit with two of the provided #6 blunt tipped screws (Figure 6).SECTION 7Finishing the Installation1. Re

Strany 7

www.airkinglimited.com6728012 Rev. J 11-14 4 of 12Installer: Installation Date: Place of Purchase: Model Number: LIMITED WARRANTYWHAT THIS WARRA

Strany 8 - 6728012 Rev. J 11-14 8 of 12

www.airkinglimited.com6728012 Rev. J 11-14 5 of 12REPLACEMENT PARTS DIAGRAM # Qty. Description Replacement Part # 1 1 Collar Assembly 5S5

Strany 9

www.airkinglimited.com6728012 Rev. J 11-14 6 of 12NOTES

Strany 10 - SERVICE À LA CLIENTÈLE :

www.airkinglimited.com6728012 Rev. J 11-14 7 of 12INSTRUCTIONS IMPORTANTES– MODE D’EMPLOILIRE ET CONSERVER CES INSTRUCTIONSLIRE SOIGNEUSEMENT AVANT DE

Strany 11 - 6728012 Rev. J 11-14 11 of 12

INSTRUCTIONS D’INSTALLATIONAVERTISSEMENT : ASSUREZ-VOUS QUE L’ALIMENTATIONE EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER L’INSTALLATION.SECTION

Strany 12

2. Fixez le compartiment de câblage à l’unité de puissance avec deux des vis #6 à tête épointée comprises (Figure 6).SECTION 7Terminer l’installation

Komentáře k této Příručce

Žádné komentáře