Air King 5000 Průvodce řešením problémů stáhnout pdf (Strana 10)

REMEDY:

• Adjust bypass damper to fully open position.

• Ensure the bypass tube is fully stretched out tight.

• Furnace filter is dirty and needs replacement.

• Bypass tube and humidifier not installed parallel, use hard

ducting – use hard ducting for any elbows – take the most

direct route when ducting.

• The bypass tube or humidifier is installed in front of air-

conditioning coils or is blocked in some other way – move to

another location and ensure maximum air flow.

• The fan delay on your furnace is not set properly and the

furnace fan is shutting off too early when the air is still hot. You

should discuss with a HVAC professional to have your

furnace’s fan cycle adjusted so you are maximizing the heat

delivered to your home. If the furnace is not adjusted you will

have to consider the use of a flow through pressure switch

(through our parts and service line) or bypass the humidifiers

control and have the unit hardwired to your furnace by an

electrician or HVAC professional.

• Your furnace is located in an enclosed space like a closet,

and as a result the temperature in that space is very hot , this

is not a good condition. Proper ventilation is necessary for

your furnace to operate properly you should consult a

HVAC professional. If this is the case you will have to

consider the use of a flow through pressure switch (through

our parts and service line) or bypass the humidifiers control

and have the unit hardwired to your furnace by an

electrician or HVAC professional.

• Your furnace is not operating properly and running too hot –

consult a HVAC professional.

PROBLEM: THE HUMIDISTAT READING DOES NOT

SEEM TO MATCH THE HUMIDITY LEVEL IN THE HOME;

IT IS HIGHER OR LOWER

POSSIBLE CAUSE: Dirty humidistat sensor.

REMEDY: Carefully clean the humidity sensor located at the back

of the humidistat. You will have to remove the humidistat from the

duct and gently blow on the sensor located at the back of the unit.

POSSIBLE CAUSE: The humidistat is located near a fresh air intake

REMEDY: Fresh outdoor air is sometimes introduced to the home

through the duct work, if you have located the humidistat near

one of these intakes the humidistat will be giving a false reading

try to relocate the humidistat to another part of the return duct.

PROBLEM: NO WATER GETTING TO THE EVAPORATOR PAD

POSSIBLE CAUSE: Humidistat is not turned up.

REMEDY: Turn up the humidistat.

POSSIBLE CAUSE: The unit is not plugged in.

REMEDY: Plug in the unit.

POSSIBLE CAUSE: The furnace is not in heating mode.

REMEDY: The furnace must be blowing hot air for this

unit to work.

POSSIBLE CAUSE: Water supply is not turned on.

REMEDY: Check to make sure water is flowing from the

piercing valve.

POSSIBLE CAUSE: Water is blocked at either the water inlet filter

or at the orifice fitting.

REMEDY: Check both components to ensure no blockage exists.

POSSIBLE CAUSE: Solenoid valve is not working.

REMEDY: Replace the solenoid valve.

PROBLEM: THERE IS TOO MUCH WATER

GOING DOWN THE DRAIN

POSSIBLE CAUSE: The unit is installed improperly and is not

performing efficiently.

REMEDY: Check your installation in the appropriate section in

the instructions and make any necessary adjustments.

POSSIBLE CAUSE: The unit is working properly and the

furnace is supplying the proper conditions – just not happy

with the water usage.

REMEDY: Flow thru humidifiers will use water. This unit has an

orifice fitting which meters the amount of water used. A total of

approx 56 US gallons will be used in 24 hours of operation. – 24

hours of operation could take as much as 3 days to complete

depending on how often your furnace cycles on. When

compared to the average shower which uses approx. 5 gallons

per minute. The amount of water used to humidifier your home

is not that much.

PROBLEM: TOO MUCH HUMIDITY IN THE HOME

POSSIBLE CAUSE: Humidistat set too high.

REMEDY: Turn humidistat down.

POSSIBLE CAUSE: Humidistat in Automatic mode and outdoor

air sensor is sensing a source of heat.

REMEDY: The outdoor air sensor will adjust the humidity level

based on outdoor air temperatures, if it is sensing air from a dryer

vent or exhaust fan vent then it will provide false readings. –

move sensor location.

Troubleshooting

1 2 ... 5 6 7 8 9 10 11 12 13 14

Komentáře k této Příručce

Žádné komentáře

Air King 5000 Průvodce řešením problémů Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Odvlhčovače Air King 5000